How to make a original wallet with brick milk.

A wallet or pruse made with a brick milk.



General objectives.


- Provide to the students the chance of achieve the knowledge, the values, the attitudes, and the neccesary interest to protect and improve the environment.


-Instill new patterns of behavior regarding the environment towards sustainable development.


-Offer a range of environmental education activities, carried out from schools, completing current educational programs.


What do we need to made it?

a brick milk.

a scissors.

insulating tape.

a stapler.

adhesive velcro.

How do we make it?

The first step is to cut the cardboard at both ends, then clean it and dry. Next, fold the sides inwards. At one of the ends fold and cut everything, about 4 centimeters, except for one side that will act as a flap for closing.

To continue, with adhesive tape, line all edges. After that, fold all the cardboard by matching the base with the mouth of the purse. Staple the two sides in the central part so that it is fixed. Finally, paste adhesive velcro to close the purse.

If the students are from the third grade of primary or higher, we can make the wallet better by introducing a variant. For this we need a tetra brick of those that have a screw cap to use it as a purse closure. For this it is necessary that:
In step 1, fold the cardboard so that the cap is in the middle. In step 3, cut the cardboard to leave the flap on the opposite side to where the plug is located. Continue the process until step 7 and fold the flap so that it is over the cap thread. With a knife scrape the flap (we have on the thread of the plug), which will indicate the circle that we must cut. Once cut, we can close the purse by inserting the screw thread through the hole and screwing the plug.